|
Farmall & IHC Tractors Discussion Board |
Re: H bull gear installation
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by '53 Super C axle gear [rp on June 13, 2007 at 13:49:38 from (66.103.227.131):
In Reply to: H bull gear installation posted by mshultz on April 25, 2007 at 18:36:32:
Hi - Noticed on the forum you've been working with your bull gears. I have to pull a right rear axle on a Super C. We're have some bad bolt problems but can see that the right side gear is loose in the box. When I get the top fully off I'm wondering if I'm goint to have a problem getting the gears back in correctly. Do you know where I can get a quick diagram of proper installation? I've called on the linked book salaes sites but so far not found one that includes this info. Just a picture which isn't good enough to bet on. If anyone has such a diagream I have a fax 2483498729 and would much appreciate it. Any additional tips not yet mentioned on the forum.
Thanks, Ed
Replies:
Home
| Forums
Today's Featured Article -
Introduction to the Gibson Model D - by Brandon Burnett. The Gibson Manufacturing Corporation was founded 1946 by Wilber Gibson. The Gibson tractors were made from around 1948 to 1952. The picture shown here is of a 1948 Gibson model D. If you notice, this tractor is driven with a lever. You could get a attachment to convert it to a steering wheel.
... [Read Article]
Latest Ad:
1997 cub cadet 7275 compact utility tractor 4wd hydro trans cracked block 3500
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
