|
Farmall & IHC Tractors Discussion Board |
1066, shifting issues again and now not starting
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Tim_in_IA on June 14, 2007 at 06:35:03 from (129.255.240.61):
Hi, I had a message a while back about not being able to shift a 1066 into gear. Turns out there are some slots inside the lever area that need to line up to shift. For some reason they get misaligned and it is a royal pain to get them lined up right to shift gears. Usually I have to shut down since I can't get to neutral and work on it a while. Well after doing this for a bit, the tractor decided not to start then. The guages show electricity but when I push the start button they blank out like there is a short or a power draw. Could this just be low battery or would this be a starter or something like that? Can I jump it with a 12 volt starter if it is battery? I am assuming it is a 24 volt system but I don't have a 24 volt charger nor do I know if they make such a beast. Does anyone know with this gear thing if there is a way to keep this from happening? Some adjustment or tightening somewhere or part replaced to keep it shifting smooth? Thanks!
-Tim
Replies:
Home
| Forums
Today's Featured Article -
The Day Tractor Lovers Dream About - by Angus Crawford. The day started at five o'clock on the morning of Friday, the January 29, 1999. My father, my sister, my uncle, my cousin and myself all climbed into my uncle's Toyota van. It was six thirty in the morning and we had a long day ahead. We traveled for six and a half hours to our destination - a little country town with a population of no more then one hundred and fifty people (57 of them being children under the age of thirteen). We arrived hoping to meet up with a man we knew had over one
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
