Farmall & IHC Tractors Discussion Board |
1586 clutch/tranny problems
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Rob on February 04, 2002 at 16:55:57 from (216.9.170.107):
I have a 1586 which has been making a loud, high pitched whinning noise that just starts when it wants to. It stops when the clutch is pushed in. Then will most likely start back up when clutch is left out. This has been going on for little while now. Well, this morning when I pushed the clutch in and went to put it in gear, the did not engage. Everything just kept spinning. I could not get into high, low, or rev. I finally just slammed the lever has hard as i could and got it to grind into low. When I was done with it and put it in reverse to put it back in the barn, it went into reverse like it should have. So I tried high and low and had no problems. What might the problem be? Is the clutch going out of it?
Follow Ups:
Home
| Forums
Today's Featured Article -
The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|