|
Farmall & IHC Tractors Discussion Board |
Old-Dutch others-1586 clutch/tranny problems contined...
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Rob on February 06, 2002 at 18:32:40 from (216.9.170.127):
I removed the inspection plate on the bottom of the clutch housing. No pieces came out. And as far as I could tell everything looked good. No play in the throwout bearing. It all looked good. The past two days, I have used the tractor and it has acted normal. Not even any whinning noise. I know that my linkage is worn. There is no doubt about that. If you're not carefull, you can get it jammed up in two gears. But, it has never acted the way it has the other day when I pushed in the clutch and evrything still kept spinning. Another thing...I am suspecting that the TA is on its way out because when I start the tractor out with a load in torque and then release the clutch, it will start out fine but then will slow down to almost a complete stop as I start up a hill, then it will just move very slowly till I take it out of torque. Then it moves fine again. Is it possible that this has something to do with my clutch not working properly the other day? Thanks for all the help.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Fordson F Ignition System - by Anthony West. A fellow restorer contacted me earlier this year asking for some help and advice on a model F that he was restoring. He had over a period of months spent a fair amount of his hard earned cash on replacement parts for the old "trembler" ignition. Sadly though all his efforts seemed to be a waste of time and money as he still couldn''t get the temperamental old thing to run correctly!! If i said that this was a little frustrating for him that would be "conservative" in fact the problem had reduce
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
