|
Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: Re: Re: Re: 3588 and 3788 same tracter
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by RPM on April 23, 2002 at 08:04:22 from (63.110.182.225):
In Reply to: Re: Re: Re: Re: Re: Re: 3588 and 3788 same tracter posted by Hugh MacKay on April 23, 2002 at 04:35:33:
This is interesting because I was a tech for 10 years also new delivery & set-up, then I always told everyone at the parts counter I was demoted to parts, anyway I am positive about the castings for these tractors, yes they have wider bull gears, different axle sizes, but in gear drive tractors as far as demensions of the basic castings they will fit and replace anything from 26/56/66/86 in the clutch housing, clutch diameter will not require change of housing, we have put 14" clutch on 966/986, rear frames are the same, axle housings ditto, been at this too long to be told otherwise. I dont expect you to take my word for it, call a good IH salvage yard, as them about this.
Follow Ups:
Home
| Forums
Today's Featured Article -
Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
