Farmall & IHC Tractors Discussion Board |
I am having a dickens of a time with the right rear wheel
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bill S on May 24, 2002 at 17:38:43 from (206.243.130.150):
I am 64 years old and I am wrestling a weighted rear wheel onto the axle and boy oh boy am I having a hard time of it. Just what is the secret to lifting the rear of the A without tipping it over, then aligning the bolts to thread into the axle!? and sliding the wheel inplace aligning those bolts? Should I take off the wheel weight, and install that alone, then install the rim? oh brother, doing this alone is one tough bean and no one's around to help since the boys moved away and the wife is out of town. Where do I place the jack to lift it without tipping it? on the left rear axle? oh brother.
Follow Ups:
Home
| Forums
Today's Featured Article -
Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|