|
Farmall & IHC Tractors Discussion Board |
different bolt patterns for hyd. pump for 300 utility H motor
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by mark on June 18, 2002 at 14:54:13 from (207.43.108.94):
I have a new old stock live hyd. pump.I think it is a {Thompson} according to the dealers parts books I looked at today.I have a 300 utility that has the same cast # on the housing of the live pump on it .Well I thought the H tractor I have was the same block so I tried to mount it on my H...well first thing I noticed was the drive gear from my old H was not fitting on my live pump .It was a couple of thousands to small.then when I tried to bolt the new pump on my old H,the two bottom holes on the flange was not exactly lined up,1/2 a hole off.Does anyone know why ?I thought a H and a 300 utility motor was same .Or is the timing chain cover on a 300 utility differnt bolt pattern? I can make it work with some drilling etc..but does anyone know more about the two?
Follow Ups:
Home
| Forums
Today's Featured Article -
Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
