Farmall & IHC Tractors Discussion Board |
Disassembled the oil drinking 706 gas this afternoon
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by andy on September 09, 2002 at 20:47:53 from (66.43.222.12):
Some of you guys responded to my post. I had a IH 706 gas that was using oil and down a cylinder. What I found was a burnt valve in the number 1 cylinder which didn't have any compression. Also it seems as if the oil rings are quite worn compared to the compression and scraper rings. The tractor had good power but used oil in excess. All of that burning oil probably put some carbon under the valve and let hot gasses begin to escape. In a matter of time a hole burns into the valve margin. The pistons look great - almost like new. The sleeves look good too. The rod and main bearings look OK but while I am there I plan on replacing them. Looks like I found my problems. Wonder what caused this to happen? Probably dirt some how. All of the air intake was tight. Intake manifold was tight to the block. Don't know how that wear would have taken place. Maybe a bad air filter at one time. Thanks guys. New question .... what should I deglaze the cylinder walls with? A deglazer with those round abrasive balls on it? I guess I prefer this kind over the flat stone type hone. How much deglazing is necessary? Thanks again. andy
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Earthmaster - by Staff. This tractor, manufactured by the Earthmaster Farm Equipment company in Burbank, California was made for only two years. The Model C came out in 1948 and was followed by the "CN" (narrow-width model), "CNH (narrow-width high-crop model), "CH" (high-crop), "D" and the "DH" (high-crop) in 1949. The main difference between the models was tire size, tractor width and cultivating height. The "D" series were about 20 inches wider overall than the
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|