Farmall & IHC Tractors Discussion Board |
cover over rear engine bearing cage on F-30
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by okla/kans Bill on June 12, 2003 at 16:42:40 from (209.240.198.63):
I noticed a bit ago, that the cover , on the inside, of the rear engine bearing cage has a groove around it around 1/2in dia and arund 10in or so across. there is a gap on the inner flange of this groove. 2 questions. first in the groove ther was somwhat like a dried paper that cracked when I touched it. Was it a gasket. It covered the groove. 2nd, what was in the groove, and third, was the cover supposed top be put on sos the gap was pointing up or down or another direction. Still wanting to know about removing the rear engine bearing cage as i posted in an earlier post. thanks for hanging with me
Follow Ups:
Home
| Forums
Today's Featured Article -
New Hitches For Your Old Tractor - by Chris Pratt. For this article, we are going to make the irrational and unlikely assumption that you purchased an older tractor that is in tip top shape and needs no immediate repairs other than an oil change and a good bath. To the newcomer planning to restore the machine, this means you have everything you need for the moment (something to sit in the shop and just look at for awhile while you read the books). To the newcomer that wants to get out and use the machine for field work, you may have already hit a major roadblock. That is the dreaded "proprietary hitch". With the exception of the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|