Re: Starter- Copper wire disconnected...

Posted by Bob on October 05, 2003 at 19:10:54 from (66.163.134.177):

In Reply to: Starter- Copper wire disconnected... posted by Matt on October 05, 2003 at 18:35:58:

To get it hot enough to solder you need an old-fashioned "soldering copper" that you heat with a torch, and then apply the hot "copper" to the connection at the stud. It must be clean and have flux applied. After the JB incident, it may take some careful scaping and wirebrushing to get it clean enough to solder. For pictures of a soldering copper go to:

http://www.tpub.com/steelworker1/56.htm

P.S. ... have a wet rag ready to cool the copper stud from the outside, to prevent damaging the phenolic insulation washers between the stud and the starter belly.

Follow Ups:

Post A Followup Name: E-Mail: Subject: Re: Re: Starter- Copper wire disconnected... Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]