|
Farmall & IHC Tractors Discussion Board |
Spoke Wheel Repair
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by week N warrior / MO on November 16, 2003 at 18:15:10 from (63.153.17.247):
The F-20 I got has on the front good spokes but the rims are bad. The guy I got it from said I could get new rims to put on there. He also said there are people to do it professionally. I was looking at them and they look like the rims have holes in them and then rivets going thru the rims and into the spokes. Is that right? Can you get predrilled rims to put on there? With new rivets? How do you remove the old rivets? Drill them out? Heat? What do the rims and rivets cost? Where do you get the rims from? What does it cost to get someone to do it for you? If I can I would rather do it myself. Rather put more labor than money into this old machine. I'm sure before it is over with I'll have plenty of both in it.
Thanks for any help you can give,
Carl
Follow Ups:
Home
| Forums
Today's Featured Article -
Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
