Re: Re: Farmall H swinging drawbar strap or rolle

Posted by williamf on December 23, 2003 at 09:11:57 from (66.82.9.18):

In Reply to: Re: Farmall H swinging drawbar strap or roller an posted by Hugh MacKay on December 22, 2003 at 18:26:22:

A prev. owner of my H had had the u bend in the middle. It was worn a little thinner right where the swinging drawbar rode. He got a salvage bar and cut it off just past the corners, right before where the angled braces attached. Then he welded it to the bottom of the u-bar so that the holes line up. You have to do sort of a double take to see what it is, that it's not just a bar as thick as it should have been from the start.
Since I use Mr. Haney mostly for pulling a trailer, often a somewhat over loaded dump trailer, I took the roller off the swinging drawbar and made a strap to hang it by, also welded half inch bar stock to the bottom to help carry the weight, and to keep it from bending while backing.

Follow Ups:

• Re: Re: Re: Farmall H swinging drawbar strap or r I knew I had a picture he 09:32:15 12/23/03 (0)
• Re: Re: Re: Farmall H swinging drawbar strap or r I knew I had a picture he 09:29:13 12/23/03 (0)

Post A Followup Name: E-Mail: Subject: Re: Re: Re: Farmall H swinging drawbar strap or rolle Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]