Re: Super MTA Electrical Question

Posted by Bob M on March 02, 2004 at 09:35:04 from (165.170.128.65):

In Reply to: Super MTA Electrical Question posted by Bob F on March 02, 2004 at 08:55:28:

Bob - Punch below for a wiring diagram for your setup.

Reason your SMTA runs on is whoever wired it up probably omitted the warning light in the alternator #1 terminal circuit. (The lamp not is there not only to warn when the alternator quits, it also limits backflow current from the alternator to the ignition coil when you open the ignition switch).

If you don't want a warning light, you can substitute a 10 to 40 ohm, 1 watt resistor. Or install a 1N4004 diode in place of the lamp (wire the diode so the banded end connects to the alternator #1 terminal)

Hope this helps...

• Super M alternator wiring

Follow Ups:

Post A Followup Name: E-Mail: Subject: Re: Re: Super MTA Electrical Question Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]