Farmall & IHC Tractors Discussion Board |
Re: Deere guy buys an F-12!
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Fred Milner on April 28, 2004 at 19:52:44 from (66.168.91.91):
In Reply to: Deere guy buys an F-12! posted by JVM on April 28, 2004 at 08:37:44:
I think you will like it a lot better if you leave the belt pully off. If you just have to have one on it they are on ebay quite often. The blocks break a lot and if the repair looks bad you may be able to grind it down a little and use JB weld to smouth it out. The JB weld will do a good job and it will last. I have used it and then sanded it to look real nice. The carberators and the fuel pumps seem to be the biggest problems. The tractors seem to flood real easy and are tempramental about starting. I know some say they don't have problems starting them but I have not seen one in person that will start easy time after time. Mine will start some times easy but not every time. Other that that clean out the oil pan and the transmission, as the trans will get water in it from time, and you should be good to go. I have an F-12 and F-14 running and 2 other F-12s to fix or for parts. Good luck and enjoy.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|