|
Farmall & IHC Tractors Discussion Board |
Re: International farmall Loboy 154
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by lee on May 19, 2004 at 12:08:55 from (216.127.206.83):
In Reply to: International farmall Loboy 154 posted by Bob Oliver on May 19, 2004 at 08:17:51:
There are 2 shear bolts on either end of the shaft 1by the flywheel and other next to the creeper drive gear box use only a grade 5 or less
If thats all turning pull the plug out of the bottom of the creeper unit if so equipt and check for frags the detent has I believe a 9/16 head bolt with a lockwasher spring and a ball Just in case you pull that out.The shift on the creeper should be smooth from low to high. My guess would the sun gears exploded.
If that isnt it pull the seat/fender assembly off and peek in top of main trans housing
(Take the shift lever plate assembly off)
good luck Let us know what happened
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Earthmaster - by Staff. This tractor, manufactured by the Earthmaster Farm Equipment company in Burbank, California was made for only two years. The Model C came out in 1948 and was followed by the "CN" (narrow-width model), "CNH (narrow-width high-crop model), "CH" (high-crop), "D" and the "DH" (high-crop) in 1949. The main difference between the models was tire size, tractor width and cultivating height. The "D" series were about 20 inches wider overall than the
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
