|
Farmall & IHC Tractors Discussion Board |
Re: International 340 Utility Hydraulic System
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by John Humphrey Morocco IN. on June 03, 2004 at 19:11:57 from (12.30.83.64):
In Reply to: International 340 Utility Hydraulic System posted by Scott on June 02, 2004 at 07:53:23:
The filter is on the right side of unit (viewed from the seat) down on the side of the trans case. There is a plate with with 8 or 10 bolts over the filter. if the unit has engine driver Hydra-touch, it has two pumps in tandem. One for power steering and one for Hydra-touch. 12 GPM for normal use and 17 GPM for use with a FEL. There is a conversion so that you can use an late model off the self filter. Gasket here can be a problem. Poor seal lets pump get air and it will growl and shorten pump life.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Fordson F Ignition System - by Anthony West. A fellow restorer contacted me earlier this year asking for some help and advice on a model F that he was restoring. He had over a period of months spent a fair amount of his hard earned cash on replacement parts for the old "trembler" ignition. Sadly though all his efforts seemed to be a waste of time and money as he still couldn''t get the temperamental old thing to run correctly!! If i said that this was a little frustrating for him that would be "conservative" in fact the problem had reduce
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
