Farmall & IHC Tractors Discussion Board |
Re: Super C Valve Clearance Cold
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Steve W (NY) on September 01, 2004 at 05:52:13 from (24.213.210.222):
In Reply to: Super C Valve Clearance Cold posted by JBlavl on September 01, 2004 at 05:38:14:
Here's what I reasoned and it seeme to work for my BN. If the push rods expand when hot, then the cold clearance should be more. I set mine to .017 cold. It's better to have them too loose than to tight. Too loose and at least they seat good....too tight, and the exhaust valves will burn. The head actually acts as a heat sink, every time the valve makes contact, heat is pulled to the head. I had mine up to operating temperature pretty quick, and retorqued the head, and readjusted the valves. It was pretty close. Take Care Steve
Follow Ups:
Home
| Forums
Today's Featured Article -
The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|