|
Farmall & IHC Tractors Discussion Board |
Re: Stuck Cranking Shaft on Farmall H M
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Mo Hay Baler on January 08, 2005 at 22:58:12 from (69.27.212.175):
In Reply to: Re: Stuck Cranking Shaft on Farmall H M posted by CNKS on January 08, 2005 at 18:07:48:
You will probably end up taking stuff off to get at it.I put some CRC Super Lube on mine and whacked it a few times with a good shop hammer.Sure enough it went in and stuck there.I then heated it and waited for it to cool just a bit,and I turned it just a little,then I lubrd it again,stuck a tire tool in there and pryed it back forward.I worked it in and out a few times,but it didnt give up so easy.I had to come up from the bottom like was mentioned earlier,and drive out the wedge pin in the shaft.Then I took it out and shined it up,and its been fine ever since.
Follow Ups:
Home
| Forums
Today's Featured Article -
When Push Comes to Shove - by Dave Patterson. When I was a “kid” (still am to a deree) about two I guess, my parents couldn’t find me one day. They were horrified (we lived by the railroad), my mother thought the worst: "He’s been run over by a train, he’s gone forever!" Where did they find me? Perched up on the seat of the tractor. I’d probably plowed about 3000 acres (in my head anyway) by the time they found me. This is where my love for tractors started and has only gotten worse in my tender 50 yrs on this “green planet”. I’m par
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
