Farmall & IHC Tractors Discussion Board |
Re: Knuckleheads!!!
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Kelly C on February 24, 2005 at 06:09:29 from (63.171.43.140):
In Reply to: Re: Knuckleheads!!! posted by Dixieland on February 24, 2005 at 04:00:27:
I am popin in this one more time. I know I am puting my foot in my mouth on this. Because this paint thing is real subjective. You guys are the ones that like it perfect when you do it. I would also suspect when you sell your tractors you dont take them to an auction. You most likely hold onto them and sell to others like you who would pay a higher price for a well dome paint job. Absolutley nothing wrong with that. Just to give an example of auction sales I have observed. last spring there were 2 Farmall B's . One you could tell some one took the time to do a real real nice paint job on it and the owner took real good care of it. It went for some thing like $1200. (I should have jumped in on this one.) The other one was nice looking had new paint but painted with out the same attention to detail the other one was. This one went for about $1100. Its obvious that the $1200 one was a bargin at that price the other was about where it should be. The thing is, it all depends on what market your looking at. That nice B should have been sold at a collectors auction. The owner might have been compinsated for all the extra work he put into it. Because guys like you will pay him for that. The local spring and fall auctions? No way am I going to strip a tractor, prime, Paint 6 coats and add hardener. For a measly 100 bucks. Now at the other end of the discusion. For personal use. I am one of those guys that want it to purr like a kittem when I hit the starter. My details are on the inside. 50 feets close enough on the out side.
Follow Ups:
Home
| Forums
Today's Featured Article -
Fabrication (Who Me? Make it myself?) - by Chris Pratt. First of all, what are the reasons for not fabricatin your own parts? Most judgements on what should be purchased rather than fabricated stem from: Originality - If the tractor restoration is to be 100% original, it is likely that you should spend the time and money to locate the component in the used or New-old-stock market. Since this can be extremely difficult, you may want to fabricate the item or purchase a modern replacement temporarily, but eventually, you s
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|