Farmall & IHC Tractors Discussion Board |
Re: Knuckleheads!!!
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by CNKS on February 24, 2005 at 13:26:31 from (204.249.178.138):
In Reply to: Re: Knuckleheads!!! posted by Kelly C on February 24, 2005 at 06:09:29:
I have yet to sell a tractor, because I haven't been doing this very long. Getting the money back is hopeless, the 2 B's that sold are typical. Unless I have a "Super MDV-TA or something, the price I get if and when I sell something will be a fraction of what I put into it -- I knew that before I started. I don't do "PPG or DuPont overhauls". I am currently working on a 460 high utility, the engine is out, reground crank and camshaft, complete overhaul kit sitting on the bench ready to install. There is no grease at all on the tractor, chassis is down to bare metal, it will be painted whenever I get all the small parts cleaned up. Paint will cost $250-$300. I repair stuff, replace seals and gaskets as I go. Because that's the way I like to do it, also why I'm always broke!
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|