Farmall & IHC Tractors Discussion Board |
Putting the engine back together
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by TKN on March 14, 2005 at 11:05:55 from (192.112.2.60):
I am rebuilding a B Farmall and am ready to put the engine back together. I have a few questions: I did not put in new sleeves, but new rings on the pistons. Do I need to hone the sleeves? There are no ridges and they look pretty clean. Do I use any sealant on the gaskets when I am putting the engine back together? Seems like I rememer my dad using something more for keeping the gasket in place than for sealing. And finally, as I put the rod and main bearings in and attach the rods back to the crankshaft, do I need to lube the bearings, pistons, cam shaft etc? Thanks for any help!
Follow Ups:
Home
| Forums
Today's Featured Article -
Converting from 6 Volt to 12 Volt - by Chris Pratt. It's a common problem for old machines especially when the weather starts to dip below 40 and the tractor isn't fired up as often. You are probably used to the 12 volt Diehard, charged with 200 amp alternator of your 3/4 ton that always is ready and always starts. It's this type of experience that brings about the many queries we get for 12-volt conversion kits. Since only a few kits are available (we sell kits for the
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|