Farmall & IHC Tractors Discussion Board |
IH 1466 - steering - MVC problems
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Murphy Ranch on July 20, 2005 at 18:50:52 from (24.225.7.207):
Having a problem with a 1974 IH 1466. The steering gets very stiff and/or jerky except at very high RPMs. Checking the flow divider valve on the side, we always find it stuck tight. Working the valve with an EasyOut in the cup end (where the spring is inserted) we are eventually able to free the spool, remove it and swab the inside of the valve body. After reassembling, the steering usually works normal for a while. Dealer has installed a new MVC pump and MVC kit (o-rings and gaskets, not sure about springs) about 1 month ago. The problem recurred after running a couple of days. Breaks continue to operate normal. All hydraulics operate normal. Clutch assist is blocked off preventing any flow through this (thought maybe this was interfering with the steering). Dealer installed the TA removal kit a couple of years ago, when it was in for a transmission R&R. Can anyone offer any suggestions on what to do next?
Follow Ups:
Home
| Forums
Today's Featured Article -
The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|