Re: Question for MAGMAN

Posted by TWM on July 24, 2005 at 16:06:24 from (206.8.10.196):

In Reply to: Re: Question for MAGMAN posted by MagMan on July 24, 2005 at 14:14:25:

MaybeI found the distributor gears. I took two screws out of a plate with a gasket and removed it, then there was a bigger plastic gear that pulled out, and a smaller gear that was part of the black plastic piece for the rotor. The poles have more surface rust than I thought they did, but it isn't deep pitting. What's there of the impulse has a lot of surface rust on the round plate part of it, and some on two pawls diagonal to each other. Some wear is there on the pawls, but I don't think excessive. Springs are there. There is also some surface rust outside of the shaft seal area. Sorry for the lack of terms, haven't had time to sit down and study on the manual yet, but I plan to tonight.

This is my first mag. I pulled it off of a parts tractor that has a distributor on it. I'd like to put parts in it, but I may lack the tools necessary to fully rebuild it (blasting or cleaning up surfaces on parts).

Follow Ups:

• Re: Question for MAGMAN Magman 18:48:58 07/24/05 (0)

Post a Followup Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]