Farmall & IHC Tractors Discussion Board |
Farmall B magneto problems
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Frank Stalfire on November 26, 2005 at 14:11:13 from (216.37.220.50):
Have an H-4 system that has just been gone thru, new coil, points, cap, rotor,condensor, plugs wires, tractor ran great, parked it a month ago now it wont start, I had taken the coil wire from the cap and put a spark plug in it and got spark but none thru the cap, replaced the cap and roto today and still nothing, but spark at the coil, now 2 hours later I can;t even get the spark at the coil. I checked the rotor timing, the rotor is about 1/4 inch behind the no.1 tower when the mag trips, I tryed to move it ahead one tooth and no difference, like I said it worked great and all I did was park it. Do I need a priest for an exorcism? Any insight would be apprieciated.
Replies:
Home
| Forums
Today's Featured Article -
Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|