Farmall & IHC Tractors Discussion Board |
Re: Anybody familiar with the Magnum motor?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by JakeF on December 02, 2005 at 12:10:11 from (64.146.188.222):
In Reply to: Anybody familiar with the Magnum motor? posted by P Backus on December 01, 2005 at 21:08:40:
Oil leaks on the front cover are fairly common. The bolts that hold the cover on get loose and the gasket blows between the block and cover. You'll either have to pull the cam or heat the cam gear and pull it off to get the cover off. Either way it's not a real big job. There is no water at the gearcase though. Are you sure it doesn't have a bad headgasket or possibly a bad oil cooler. You'll also need a special seal installer to put the new seal/wearsleeve on the crank when you reasseble it. Good luck.
Replies:
Home
| Forums
Today's Featured Article -
Check Your Coolant - by Bill Radford. Great tips on how and when to check the coolant in your tractor.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|