Farmall & IHC Tractors Discussion Board |
More Hydro Stuff
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Allan in NE on December 21, 2005 at 16:44:11 from (148.78.243.26):
So, I pull the side cover, the pipe, the reverse check valve plug and the forward regulator. All seem just fine. However, that control cam/variable orifice waffer seems awfully sloppy against the pump servo. Should that thing have 3/16" of sideways slop to it? Just doesn't seem right. The whole control business seems excessively sloppy. How would it ever seal? Am I on the right track or should I button 'er up and haul it to town? Thanks, Allan
Replies:
Home
| Forums
Today's Featured Article -
The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|