Farmall & IHC Tractors Discussion Board |
Are You Sure?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by rumplestiltskin on February 21, 2006 at 06:47:46 from (65.216.75.240):
In Reply to: Re: Hydraulic problems posted by Janicholson on February 21, 2006 at 06:29:40:
Jim: I get a different answer. The area of a circle is "pi times (r squared)". In this case, assuming a two-inch cylinder means two inches in diameter, r = diameter/2, so r=1 and r squared =1. So the area is pi times 1, or pi, or roughly 3.14 square inches. Then again, I could be wrong...Maybe someone "out there" can double-check our work and confirm one or the other. It looks like maybe you were squaring pi instead of the radius to get your answer. Mark W.
Replies:
Home
| Forums
Today's Featured Article -
Listening to Your Tractor - by Curtis Von Fange. Years ago there was a TV show about a talking car. Unless you are from another planet, physically or otherwise, I don’t think our internal combustion buddies will talk and tell us their problems. But, on the other hand, there is a secret language that our mechanical companions readily do speak. It is an interesting form of communication that involves all the senses of the listener. In this series we are going to investigate and learn the basic rudimentary skills of understanding this lingo.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|