Farmall & IHC Tractors Discussion Board |
Got the H home and wheels switched! (Pics)
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Ryan in PA on March 13, 2006 at 08:46:02 from (146.186.41.220):
Hey Everyone. Finally got my 1946 Farmall H Home. Before we moved it from the dealer we switched the back wheels becasue they were dished in and i just couldn"t get any width on the back for better stability. So we used a crane that had to be 50+ years old, he says he doesn"t move, they jsut use it for unloading. After some ether and warm up that old crane started well! the wheels weren"t too bad to get off. WE had been spraying them. They def had fluid in them and we used a front end loader to move the wheels. took about 3 hours to do and then off to home it was. I"ll post as many pics as i could! Ryan
Replies:
Home
| Forums
Today's Featured Article -
The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|