Farmall & IHC Tractors Discussion Board |
Re: Farmall M Belly Pump Oil Q's
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by CNKS on March 13, 2006 at 19:56:31 from (204.249.178.138):
In Reply to: Re: Farmall M Belly Pump Oil Q's posted by Andy Martin on March 13, 2006 at 17:44:36:
I drove an H with front and rear cultivators with the delay valve. Seems it worked sometimes and sometimes not. I think we gave up on it. I don't know if I knew about the "hold at last position" feature. I would "bump" it down by pushing the rod forward and then back to the neutral position, same way with raising it. Did that only when I did not have the depth set right with the adjustments/levers on the cultivator itself, or because of varying soil conditions; but I do remember that sometimes the cultivator would not drop all the way until I pushed again (if I remember right), been 50 years, can't remember what I did this morning. Perhaps I had found the last position thing and didn't realize it until now--too late.
Replies:
Home
| Forums
Today's Featured Article -
Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|