Farmall & IHC Tractors Discussion Board |
Re: Need hydraulic help, NH3 valve on air seeder
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by billonthefarm on April 10, 2006 at 19:02:13 from (204.42.18.221):
In Reply to: Need hydraulic help, NH3 valve on air seeder posted by Steven@ND on April 10, 2006 at 18:11:04:
Steven I have seen it done like that and it did work. I know they were hooked into the main raise lower lines. In any system the cylinder that needs the least pressure will move first. My recolection was that before you raised the nh3 toolbar if you bumped the lever it would shut off the flow and then wait a second and then complete the lifting. When you lowered the weight of the implement will keep the valve for the nh3 closed untill the implement was in the ground. Good luck and make sure you try it a few times before you go to the field. bill
Replies:
Home
| Forums
Today's Featured Article -
Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|