Farmall & IHC Tractors Discussion Board |
6v charging system problem
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by jim barlow on May 11, 2006 at 14:54:34 from (216.209.120.100):
this 6v pos grd 3 brush gen , reg ;charging system has been working fine till just recently it quit charging. I disconnected both armature and field leads from gen and put voltmeter from armature to ground, got no volt reading, flashed field and got about 2.5v from residual magnetism. now added field from same polarity as flashed with and gen charged backwards. Repeated this test and got sme results. The generator is a delco remy 3 brush generator but the brushes have absolutely no adjustment. They are all permanently mounted to a non adjustable ring in the end bell. Would any one tell me what I am missing in this problem Thanks jim
Replies:
Home
| Forums
Today's Featured Article -
Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|