Farmall & IHC Tractors Discussion Board |
340 Utility Hydraulic Oil Leak
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Rockbasss on May 20, 2006 at 17:31:17 from (69.95.143.93):

I bought a ‘61 340 Utility a while back and am trying to clean it up some, to start with. If any one has an educated guess as to where this leak is coming from I will appreciate your thoughts. The black arrow is pointing to a hole in the casting that the oil is leaking from. It didn't leak from there to my knowledge until I rebuilt the cylinder on the 3 pt. That shouldn't have caused it unless pushing the oil into the cylinder caused a gasket to start leak above the casting hole? In any case I still want to find the leak before I change the trans hyd oil and the filter. The picture is taken looking from the front towards the rear. Thank you, Rockbasss
Replies:
Home
| Forums
Today's Featured Article -
Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|