|
Farmall & IHC Tractors Discussion Board |
SAV front axel pivot
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by RedJohn 2 on May 30, 2006 at 19:26:41 from (65.33.39.225):
Concerning a Super AV: If you disassembled the front end completely I am very interested in just exactely how to reassemble one. I'm trying to reassemble the pivot shaft into the new bushings in the axle and the accompaning openings in the lower steering housing. I did set up the axel in my press and pressed the shaft through both the axel bushings, so I know it will go. I pressed the shaft back out. Now I'm trying to repeat the process for real ....on the tractor. There is so much resistance when trying to push the shaft through the openings and bushings, I'm wondering if I must set up some squeeze/press/vise-type set up. If anyone can lend me any advice, I will be most beholding. Thanks.
John
Replies:
Home
| Forums
Today's Featured Article -
When Push Comes to Shove - by Dave Patterson. When I was a “kid” (still am to a deree) about two I guess, my parents couldn’t find me one day. They were horrified (we lived by the railroad), my mother thought the worst: "He’s been run over by a train, he’s gone forever!" Where did they find me? Perched up on the seat of the tractor. I’d probably plowed about 3000 acres (in my head anyway) by the time they found me. This is where my love for tractors started and has only gotten worse in my tender 50 yrs on this “green planet”. I’m par
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
