Farmall & IHC Tractors Discussion Board |
Geoff NY
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by CNKS on June 07, 2006 at 18:19:57 from (204.249.178.138):
Looks like no one answered your frame width question. This is an apple and orange thing, but maybe it will inspire someone to do some measuring. I am comparing a Super H to a 460, not an SWD 6 to a 560, or late model TD 6. The widest point of my 460 C221 block is 13 inches, excluding the place for the dipstick. The distance between the frame rails on my Super H is 15 inches, on my M about 16 1/2 inches (too much in the way to get a straight shot). This means that the C221 will fit between the frame rails of a Super H, or an H for that matter, unless the dipstick housing is in the way. Surely someone can measure between the frame rails on a 560. I bet a D282 will fit between the rails on your SWD 6, but someone needs to measure. Someone can (and probably will) correct me, but I think the dimensions of the block, from the C221 to the D301 are about the same -- that one should get a response). From what you said it looks like the start on gas 4 cylinder diesel was used about 10 years longer in the TD 6 than in anything else.
Replies:
Home
| Forums
Today's Featured Article -
Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|