Re: outer axle bearing in 300 farmall

Posted by GordoSD on June 07, 2006 at 19:32:56 from (66.115.200.140):

In Reply to: outer axle bearing in 300 farmall posted by MoMike on June 07, 2006 at 17:53:20:

I did both my H and the SMTA. Fortunately I did the H first and found that lining up that bull gear with the axle was a little (lot) tricky. Now the SMTA bull gear is about twice the weight of the H. So I made a wooden spacer block, just the size of the space between the gear and the bottom of the case. Wedged it in there before pulling the axle. It took about 10 seconds to slide that axle and housing right back in there, as the bull gear was still there perfectly aligned.
I'd replace both inner and outer. You can tell if there is wear there if you get a "lurch" when you apply the brakes.

Gordo

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]