|
Farmall & IHC Tractors Discussion Board |
Re: Hooking up hydraulics for loader on 706 (pictu
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by K.B.-826 on August 29, 2006 at 13:27:39 from (68.115.105.80):
In Reply to: Hooking up hydraulics for loader on 706 (picture) posted by Steve KS on August 29, 2006 at 12:52:30:
One of those is the relief valve, can't remember what the other one is. Don't mess with those. I would recommend fixing that handle for your second remote. That way, you could plug your loader valve into the couplers that valve controls, and just tie that lever back so it's on demand at all times. There may or may not be a plate on the left side of your left remote valve. If there is, you can remove that plate and buy a power beyond plate to bolt on in it's place. Those are usually availible from salvage yards, and I believe some guys are making new ones as well. The power beyond plate will be threaded, so you just screw in hoses and run them to your loader valve. I think those plates sell for around $100.
Replies:
Home
| Forums
Today's Featured Article -
Farmall 460: That's My Girl - by LeAnn R. Ralph. How many sounds can you think of that are as familiar to you as your own breathing? What about the hum of your refrigerator? Or the thump of your clothes dryer? Maybe the engine of your car? You hear those sounds every day, and you don't think much about them, do you. I can think of a few common, ordinary sounds in my daily life, too.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
