Farmall & IHC Tractors Discussion Board |
Re: a related part
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Wardner on October 18, 2006 at 19:15:47 from (4.154.241.159):
In Reply to: Re: a related part posted by Wardner on October 18, 2006 at 18:53:46:
I went to my 460 book first. The couplings you mentioned have the same part number as the 560. The 460 book does not list the clutch type PTO, only the planetary. The three piece shaft assy is 360 167 R11. The 504 book list the same couplings as the 560 and 460. It only lists the clutch type PTO. The shaft assembly is 307 224 R11 until tractor # 14334. After that it is 395 132 R11. I have a feeling you will need to get a measurement on what you think the lenght of the shaft will be. All the splined ends will be the same. A salvage yard should be able to send you the right shaft if you specify the length.
Replies:
- Thanks Charlie 19:42:08 10/18/06
(0)
Home
| Forums
Today's Featured Article -
Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|