Re: super a rebuild advice

Posted by El Toro on October 23, 2006 at 15:49:35 from (152.163.100.65):

In Reply to: super a rebuild advice posted by werowance on October 23, 2006 at 12:06:59:

That engine doesn't have cam bearings. You should
do what Dave recommended on the pump. I think
the gears may be available. I have a parts breakdown on the Super C pump if you need it.

You should have the crankshaft measured for wear.
Your mains may be worn and close tolerances on these determine good oil pressure too. If the shaft is worn a few thousandths you can use .002" undersize bearings. I did that on an A Farmall.
This engine had so much sludge in it I don't know how any oil got to the bearings. Hal

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]