|
Farmall & IHC Tractors Discussion Board |
Re: Engine ID question
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Hugh MacKay on February 10, 2007 at 14:53:15 from (209.226.247.128):
In Reply to: Engine ID question posted by Chris from Wa on February 10, 2007 at 12:23:35:
Chris: Does it have engine cubic inch cast letter and numbers near or behind oil filter. example C-123, C-135, etc. The letter Z indicates 1954. To my knowledge, all of the engines that will bolt up to a Super C are exactly same length. What makes you say this engine is shorter? You obviously have a reason. Could it be that someone has installed the wrong hood? A Super C water pump should bolt on over the lower engine water jacket port, and be driven by the main fan belt. On the older thermosyphon tractors fan belt went around crank and fan pullies only. Your fan belt should go around three pullies; crank, fan and water pump. Tell us more, and no jokes until after 10 pm .
Replies:
Home
| Forums
Today's Featured Article -
Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
