|
Farmall & IHC Tractors Discussion Board |
Re: M engine - How would you build it?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by georgeky on August 08, 2007 at 14:47:18 from (64.12.117.137):
In Reply to: Re: M engine - How would you build it? posted by the tractor vet on August 08, 2007 at 12:59:26:
Vet, I have not had either of my M's on a Dyno, but I am certain that neither will clock anywhere near that. We did put Brads SMTA on one after I finished it and it was turning in the 70+ range. He had it hooked to an irrigation pump with three guns and it would shoot the water. I used it a while hooked to a 10 foot JD heavy disk and it didn't really seem to be much stronger than my old M hooked to the same Disk. Looks like 90+ HP would gut the old gal, but I don't know as I never had one turning that much. How much can I get out of the 450 diesel? I would like to have at least 70 out of it if possible for as little money as I can get by with.
Replies:
Home
| Forums
Today's Featured Article -
Farmall 460: That's My Girl - by LeAnn R. Ralph. How many sounds can you think of that are as familiar to you as your own breathing? What about the hum of your refrigerator? Or the thump of your clothes dryer? Maybe the engine of your car? You hear those sounds every day, and you don't think much about them, do you. I can think of a few common, ordinary sounds in my daily life, too.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
