Posted by Hugh MacKay on August 25, 2007 at 02:58:22 from (216.208.58.164):
In Reply to: Re: ih wide front posted by Goose on August 24, 2007 at 20:04:15:
Goose: Hydrostatic steering has nothing to do with this question. The 560 was non hydrostatic, whereas 56 series were, yet the steering function was transfered through the front bolster in both. The basic difference in the 66 series front end, still hydrostatic, yet the steering function was transfered via hydraulic lines driect to a steering cylinder behind the front axle. To mount a 66 series front end on a 560 or 56 series, it's as simple as removing the steering cylinder, steering control arm and hooking the tyrods direct to the steering control arm on 560 or 56 series. One could mount that 66 series front end on a SM, 400 or 450 with no power steering, just as easily.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
