Posted by scott#2 on January 30, 2008 at 18:11:40 from (151.200.24.118):
With the majority of all the discussions on this forum centering around old american iron, I am surprised that there isn't a catagory on the left entitled MADE IN THE USA. This could be a place where people could post USA companies that produce quality produsts, not tractor parts that could cut into this sites life, just tools and such. Case in point: I needed a new hyd. cylinder for a engine crane and was tired at looking at all these jap jobbies that looked like they would leak or fail after a few cycles. I stumbled across usjack. All american made and a price tag I didn't consider too bad, considering that they were designed for, I believe 5000 cycles at max load before giving up. I bet a Jap job can't say that. What do you guys think and the moderator/webmaster too?
Isn't it time we started supporting our own industry, even if it cost us a little more?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.