Posted by Wayne from MN on January 31, 2008 at 12:32:38 from (66.228.243.49):
In Reply to: Re: M MAIN BEARINGS posted by Janicholson on January 31, 2008 at 11:08:04:
I have a set of .002" bearings that we tried to put in a '54 SMTA. The old ones were marked .002" so just replaced them. For what ever reason they tightened up too much on the outer edges of the new bearings and the crank was too tight to turn over. So, we pulled the crankshaft out, took it to the local machine shop and had it reground. Now with 010" undersise bearings it turns freely. Make an offer if you are in need of some .002" bearings. Email is open.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
