Posted by farmall dave on February 25, 2009 at 04:50:43 from (69.128.228.164):
Hello all, just got done with putting power steering on my old "58 300u. When finished put new oil back in the resevoir and pulled it outside to see if everything worked ok. The power steering worked fantastic and I was very pleased, so I put on the back blade to clean up a road and at first the fast hitch went up and down fine, but after a half hour or so, it goes up and down very slow and acts like no pressure. Steering still works fine. I see no leaks and the pump is not running any harder than it had. Any ideas of what to check for?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
