Posted by rebel70blue on July 02, 2009 at 16:07:21 from (74.76.31.231):
New here-
I bought a 3514 loader backhoe that was running strong last season, but has been extensively "tinkered" on in an attempt to get it restarted this year.
Prior owner did not disrupt timing, but replaced all electrical components (wires,coil,dist,points,etc.)
Ruled out fuel issues and now turning attention to electrics.
Found the wires hooked up wrong (running clockwise rather than counterclockwise).
Right now it fires 3x"s on ether then quits.
Current questions:
With the motor at TDC, should the rotor be pointing to #1 or #4 ?
Is this a + or - system ?
Would be a great help if a fellow owner could snap a picture of the cap + wires to get orientation correct.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
