Posted by Mike CA on November 03, 2009 at 16:57:11 from (99.28.152.102):
A tractor restorer from my club came over today, looked at the tap and said "that should be easy". Took a thin chisel he brought, and proceeded to pound the heck out of it. Broke it apart in less than 5 minutes.
Now the hole is clear and clean. I need to get a new tap, and this time do it slower. Then put in the stud, then I'll be back in business.
Ok, so... tips I've learned:
Go slow with the tap. Quarter turn, back it out, clean it. Back in, cut a quarter turn, back it out, clean it.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
