Farmall & IHC Tractors Discussion Board |
leaky 300 ult.
[ View Follow Ups ] [ Post Followup ] [ Return to Farmall & IHC Tractors Discussion Board ]
Posted by curtis on May 24, 2000 at 12:27:10 from (63.10.144.89):
i am working on a 300 ult. at my local high school it belongs to our ffa chapter so we are fixing it up and we got it running and it runs really good nice motor and everything we only have 2 problems with it. the first is that the fingers are sticking on the pressure plate and causeing the clutch not to fully disengage so it grinds the gears a bit but no to much. and the second problem is that where the clutch inspection plate is it leaks hytrans. fluid and i was woundering how hard is it to split a tractor of that size to put a seal in it and could we do it useing a moter lift and some blocks or should we take it to the local dealer and pay them money to fix it for us?? i want to know all your thoughts on this thanks in advance.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|