Posted by Zachary Hoyt on July 01, 2010 at 17:58:48 from (184.8.250.186):
Thank you Janicholson for your help with my last post. I got a new cap for it as I had gotten rid of the old one a couple of months ago since i thought it might be cracked. I still had the old rotor since it seemed fine. I have tried every permutation of cap and rotor, I tried taking off all the plug wires from the cap except one, still no fire. I am getting good spark from the coil, though. I tried putting my hand on the cap, the coil cap, the wires and the body of the mag and did not get a shock anywhere while holding the starter button down I thought about what you said about the cap and rotor being out of alignment, but I haven't done anything that should have changed them. I tried not putting the rotor on quite all the way to see if that would bring it closer to the contacts, but that didn't help. The contact in both caps looks good, the rotors are complete with tab and everything looks okay. Is it possible to get the tab too close to the contacts in the caps? I will be very grateful for any advice anyone may have. I am at my wits end, not that that is very far away, but still......... Zach
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Pitfalls of Tractor Engine Rebuilds - by Chris Pratt. The first pop after you have put the machine together with your own hands is exciting and pleasing. The whole experience can be marred if one moves too fast and makes too many assumptions that they can just use "as is" some parts they should be closely scrutinizing and possibly attended to. In such cases, rework makes what could have been a fun project turn into an irritant or even a nightmare. Minor Irritants To give you an example of an minor but irritating proble
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
