|
Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: Re: Re: Re: Re: Hey Red...CUB Engine Noise...Need Further Advice
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by george on July 29, 2000 at 12:32:54 from (172.161.61.238):
In Reply to: Re: Re: Re: Re: Re: Re: Re: Hey Red...CUB Engine Noise...Need Further Advice posted by George Willer on July 29, 2000 at 10:43:05:
George: I didn't pull the rod caps off, however I did inspect the cylinder walls...no scoring or indications the piston is moving abnormally. There is slight lateral movement in the piston rods at the crankshaft, althouth there is no roof for any twist. I'm sure the bearings are worn, but I don't see enough play to make the knock I'm hearing. Oil pressure is good also. I put the pan back on and ran around the yard for a while. The knock seems to dissapear (perhaps lessen considerably) when the engine is under strain or under high vaccuum. It's most pronounced when simply "running" at higher rpm. I'm going to take another look at the valve clearance. I need to get a .013 guage with an offset so I can get it down into the access opening.
Follow Ups:
Home
| Forums
Today's Featured Article -
Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
