|
Farmall & IHC Tractors Discussion Board |
3 pt hydraulic ram problem
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bama Binder on September 01, 2000 at 08:33:12 from (206.5.110.15):
OK...As I was going through the hydraulics on my Super H with an add on 3pt conversion, I ran across a puzzling problem (to me anyway). The hydraulics go up fine, but as they are going up, hydraulic fluid is being vented from the ram. It does not appear to be leaking from the piston seals but from the underside of the ram. I have not looked at it carefully, but I think there is a hole at about the midpoint of the ram. My first thought was that it is an overpressure relief, but if so, It must be worn out because there was no weight on the hitch. Any ideas about what is going on here? Also, can the Super H be rigged for double acting hydraulics and if so, how? Any help is apprecited...BB
Follow Ups:
Home
| Forums
Today's Featured Article -
The Fordson F Ignition System - by Anthony West. A fellow restorer contacted me earlier this year asking for some help and advice on a model F that he was restoring. He had over a period of months spent a fair amount of his hard earned cash on replacement parts for the old "trembler" ignition. Sadly though all his efforts seemed to be a waste of time and money as he still couldn''t get the temperamental old thing to run correctly!! If i said that this was a little frustrating for him that would be "conservative" in fact the problem had reduce
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
